On Wednesday, September 4, 2024 at 2:32:06 PM UTC-4 J J wrote: It's either defective or plain awful design and manufacturing.
It's certainly not the latter as mine work fantastically. And considering how simple the device is it's hard to see what could be defective. The hole? The nut? The entire process is by turning that nut you are pulling the shaft it threads onto towards the nut, eventually the cable is being pinched both at both top and bottom. What I find hardest to understand is how Michael was able to tighten the nut to "a very light tension" off-bike and have it hold the cable fine, but can't seem to replicate that on-bike. I think if over-tightening had somehow deformed the hole you'd be able to notice it. If you're not bottoming out the acorn nut I gotta think you can tighten it further, I could be wrong but I'd think the cable would fail before the solid block of the yoke or the shaft would. -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/rbw-owners-bunch/8f5b1905-7b9d-47ab-8381-49b21d5a7027n%40googlegroups.com.
