I've uploaded the design of my Cromwell's drive sprocket. Check out TTS Sprocket.pdf in the files section.
Steve Tyng On Dec 9, 11:14 pm, "Chrysanthos Kanellopoulos" <[email protected]> wrote: > Glad to hear. It was ony a few minute break at work here. > Chrys > > > > ----- Original Message ----- > From: "Joker" <[email protected]> > To: "R/C Tank Combat" <[email protected]> > Sent: Tuesday, December 09, 2008 11:17 PM > Subject: [TANKS] Re: Drive Cog Patterns > > > Thanks. This was great. I took the photo, scalled it, inverted the > > colors, and i'm using it as the template. Thanks again. > > > On Dec 8, 4:41 am, "Chrysanthos Kanellopoulos" <[email protected]> > > wrote: > > > The diameter of the inner circle (green) could be 0.0873, with the clear > > > distance between the teeth 0.0350 = 1 3/8". That way, the pads fit > between > > > the teeth. > > > The width of the tooth ~ 0.064 or 0.0638 m. or 1/4" wide. > > > The diameter of the outer circle, on the edge of the teeth would then be > > > 0.0993 m. = 3,901 " > > > I hope that helps and it is not more confusing! > > > > Chrys > > > > JOkers sprocket7.3.jpg > > > 123KViewDownload > > > > JOkers sprocket7.4.jpg > > > 66KViewDownload > > > __________ NOD32 3434 (20080911) Information __________ > > > This message was checked by NOD32 antivirus system. > >http://www.eset.com > > --~--~---------~--~----~------------~-------~--~----~ You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat -~----------~----~----~----~------~----~------~--~---
