thats a great help thanks, think i will need to do a bit of re- designing. I have seen on internet in USA a M1A1 with marker so I think i need to take a closer look at what was done with that one to make the marker work.
many thanks again On May 31, 7:30 pm, Jeremy Caylor <[email protected]> wrote: > An ASA is where you attach the air source to. Most people relocate it to > make air tank placement easier in the turret. It's held on with 2 screws so > it's easily to relocate. > On May 31, 2011 1:28 PM, "Andy_Basildon" <[email protected]> wrote: > > > > > > > > > it does thanks, 8" is a lot of area, naive i am, what is the ASA? > > looking at the scale i only have a about 3" from the pivot of the > > barrel to the top of the turret, not alot although as I said I could > > make the turret higher > > > On May 31, 7:05 pm, Jeremy Caylor <[email protected]> wrote: > >> Well I dug out my old A5 to take some measurements for you. The length > >> (minus barrel) is about 11.5", height (with vortex feed) is about 8" from > >> top of the feed to the asa, and the width is aprox. 3" (+/- 1/2" with the > >> charging handle). Hope this helps out! > >> On May 31, 2011 12:58 PM, <[email protected]> wrote: > > > -- > > You are currently subscribed to the "R/C Tank Combat" group. > > To post a message, send email to [email protected] > > To unsubscribe, send email to [email protected] > > Visit the group athttp://groups.google.com/group/rctankcombat -- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat
