Some caveats.... * You are welcome to use the documents with the realization that you accept 100% of the risk and responsibility for doing so. The author assumes no liability of any sort. These are NOT intended as a comprehensive guide to building a 1/6th scale r/c paintball tank. Checking the accuracy is up to you.
* The document labeled "An alternative idea for road wheel bearing mount and suspension" is an idea for using two self-centering bearings mounted to the inside and outside of the hull wall with no internal rail mount for the inside bearing. This will put a sh*tload of strain on the hull wall and should only be considered if YOU build the hull strong enough to support this. * There is virtually no mention of construction material or a parts list. That would be entirely up to the would-be builder. * Suggestions welcome but don't take it personally if I don't act on it. It's not you. I'm just busy with my life. * Criticisms should be written down in ink on paper, folded neatly into a one inch square and swallowed whole and this too shall pass. :-) Cheers, Fred -- You are currently subscribed to the "R/C Tank Combat" group. To post a message, send email to [email protected] To unsubscribe, send email to [email protected] Visit the group at http://groups.google.com/group/rctankcombat
