good day Wrenches,
I've had a list of questions to pose. Please excuse me if these have been
addressed previously.
1. What are your thoughts on using dielectric grease on terminal
connections?....especially on exterior connections, even if those connections
are in a weather-tite enclosure.
2. What are you using for a torque setting for 1/4-20 module clamp bolts? Seems
most manufacturers spec 15 ft.-lbs. We have found this to be too high
(especially with t-bolts) and are using ~ 140 in.-lbs.
3. A tip on module glass: We recently had some Evergreen 170's stored on a roof
(flat) for a project (uncovered!). The roofers decided that they would make a
good workbench and when we went to install there was some caulk (urethane?) on
the face of one of them. After trying to remove the caulk with a wood shim, I
tried using mineral spirits which, of course, was totally ineffective. The
roofers happened to have some acetone on-hand which I borrowed and removed the
caulk...big mistake. After installation, it was obvious that there was a module
with "smudges" that we could not wash-off. I contacted Evergreen about this but
was unable to receive an answer to my question as to whether-or-not the acetone
had etched or removed the anti-reflection coating. I think that it did. We
replaced the module.
thanks,
Tom
Tom DeBates
Habi-Tek
524 Summit St.
Geneva,IL. 60134
630-262-8193
fax 630-262-1343
_______________________________________________
List sponsored by Home Power magazine
List Address: [email protected]
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
