I have a customer with a link 10 meter that keeps resetting and flashing. The wires are tight on both ends and i have not been able to get it to reset while I am on site.
It runs throught a 2 amp fuse that has not blown and it gets it's main power from the battery side of the main breaker. The battery bank is large so sudden voltage swings are not the problem. The meter is 1.5 years old and has done this from initial install. The owner did not know it was unusual.... The voltage on the meter agrees with the battery voltage in the power building so i don't think it is a case of voltage drop. I am taking a 3 hour drive Saturday and would like to figure it out. I have installed a few dozen of these and have never had one reset unless it had it's power disconnected and if it's doing that, i can't catch it. Anyone got any ideas? Thanks, Bob
_______________________________________________ List sponsored by Home Power magazine List Address: [email protected] Options & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org
