Kirk
I am currently in Namibia, so email or phone calls are a bit of a pain... I have asked Sandra In tech support to call you and help you with this if that ok with you? Steve Higgins Sr Application Engineering Mgr Sub-Saharan Africa Business Dev Mgr. Direct: 360-618-4314 OutBack Power Technologies 19009 62nd Ave NE, Arlington, WA 98223 USA Tel: 360.435.6030 Fax: 360.435.6019 www.outbackpower.com From: re-wrenches-boun...@lists.re-wrenches.org [mailto:re-wrenches-boun...@lists.re-wrenches.org] On Behalf Of Jeff Oldham Sent: Thursday, August 12, 2010 10:26 AM To: re-wrenches@lists.re-wrenches.org Subject: Re: [RE-wrenches] generator surge on outback system The Cool Down program does disconnect the genset from the inverter (xfer & charger) for the cool down cycle. This likely will solve your issue. If the genset was not disconnected the it would remain loaded and there would not be a cool down. The whole point of cool down is to have the loads removed so the turbo can cool slowly to mitigate and deformity. In most modern machines this is generally no longer an issue, but again it should solve your surge. -jeff o >From the Solar, Wind and Hydro powered office of Jeff Oldham/Regenerative SOLutions ____________________________________________________________ Get Free Email with Video Mail & Video Chat! <http://www.juno.com/freeemail?refcd=JUTAGOUT1FREM0210> MESSAGE CONFIDENTIALITY NOTICE: This message (including attachments) is covered by the Electronic Communication Privacy Act, 18 U.S.C. sections 2510-2521, is confidential, and may also be protected by attorney-client or other privilege. If you believe that it has been sent to you in error, please do not read it. If you are not the intended recipient,you are hereby notified that any retention, dissemination, distribution, or copying of this communication is strictly prohibited. Please reply to the sender that you have received the message in error, then delete it. Thank you.
_______________________________________________ List sponsored by Home Power magazine List Address: RE-wrenches@lists.re-wrenches.org Options & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org