I continue to have issues with inaccurate MX60 meters, I can calibrate for
EITHER the lower voltage setpoints OR the higher but can't get accuracy across
full scale. I've seen this on nearly every MX I've been around. This has forced
many a customer to run to start their genny on low V falsely. It will display
12.2V when reality is 12.6V. Outback has not adaquately address this to me as
of yet and at one point they offered to update the software in several MX's
that I'm involved with. When they came back the metering error was still there
and now they will no longer communicate with the MATE completely. You can
access about 1/4 of the data at best. They then updated several MATES and still
little communication. We don't know if it is a MATE issue or a MX one. This has
been a giant step backwards and they tell me that they cannot put back the old
codes. They also have not been able to tell me if the new MATE just released
can fully communicate with older MX's after several requests for an answer. If
you think updating a customers older products will make them happy with your
awesome service take a long pause. I would be nervous updating a MATE on an
older system and certainly would not do a MX. -jeff From the Solar, Wind and
Hydro powered office of Jeff Oldham/Regenerative SOLutions
____________________________________________________________
Globe Life Insurance
$1* Buys $50,000 Life Insurance. Adults or Children. No Medical Exam.
http://thirdpartyoffers.juno.com/TGL3131/4d5477de5e3a33050d5st02vuc
_______________________________________________
List sponsored by Home Power magazine
List Address: [email protected]
Options & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
www.re-wrenches.org/etiquette.htm
Check out participant bios:
www.members.re-wrenches.org
