I use them, and have one at my house. The biggest issue I have with M2 is that people mess up getting to the reset of the AGS mode.
With the M3 that is a separate button which is a big improvement. And that you can reprogram it via SD card is a big improvement. Try that with a XW! Overall its easier in some ways, more complicated in others. Jay peltz power On Oct 20, 2012, at 11:20 AM, Dave Palumbo wrote: > Howie, > > We have a couple of these out there now. They are good for techno geek > types. But for regular people they are no easier than the Mate 2. > David Palumbo > > Independent Power LLC > 462 Solar Way Drive > Hyde Park, VT 05655 > www.independentpowerllc.com > NABCEP Certified PV Installer > Vermont Solar Partner > 25 Years Experience, (802) 888-7194 > > > Dave > > -----Original Message----- > From: [email protected] > [mailto:[email protected]] On Behalf Of Howie > Michaelson > Sent: Saturday, October 20, 2012 2:10 PM > To: RE-wrenches > Subject: Re: [RE-wrenches] Outback Mate3 > > Thanks Daryl for the feedback. > > Have you or anyone else used the Mate3 on a VFX or GVFX, and is that an > improvement over using the Mate2? > > Howie > -- > Howie Michaelson > NABCEP Certified Solar PV InstallerT > > Catamount Solar, LLC > Renewable Energy Systems Sales and Service VT Solar Electric & Hot Water > Incentive Partner http://www.CatamountSolar.com > 802-272-0004 > > > On Sat, October 20, 2012 1:55 pm, [email protected] wrote: >> Hi Howie, >> Having installed a half dozen Radians so far I have gotten >> comfortable fairly quickly with the Mate3. It is much more intuitive >> than the original Mate and uses a touch pad similar to an Ipod. I have >> had an issue a couple of times not being well grounded and the touch >> pad was a bit buggy then, but overall the Mate3 is quite an >> improvement over it's predecessor. >> The screen interface showing the FNDC is similar to the Mate2. >> I do think that everyone has varying degrees of intuitiveness about >> remotes and on a scale of 1 to 10 I am probably a 6 at best, and yet I >> found the Mate3 easy to maneuver and program. I am now using one on my >> own system. Just one mans opinion, of course..... >> >> Daryl >
_______________________________________________ List sponsored by Home Power magazine List Address: [email protected] Options & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org
