I can show how we did the same thing on a flat roof using unistrut and angle iron for 3 x SMA 20kw Tripowers and a 400A panel. All we had was a $100 MIG welder. We put some roof steel sheet above the inverters. I will have to look for photos.
Chris Mason Comet Systems Anguilla (264) 235-5670 St. Kitts (869) 662-5670 skype netconcepts NABCEP Certified Solar PV Installer™ Renewable Energy Systems professional Generac Generators Factory technician On Apr 29, 2014 6:11 PM, "Allen Frishman" <[email protected]> wrote: > Hey Wrenchers, > I am looking for suggestions for building a shade structure on a flat roof > for inverters and load center. There is no bulk heads on this flat roof > and it is a zero lot building so there is no exterior wall available to > hang the inverters. No space inside the building either so the roof is > the only option. Any suggestions? I will be using a ballast racking > system so the array will not provide any shade. > > All ideas welcome and appreciated! > > *Al Frishman* > AeonSolar > > *(917) 699-6641 <%28917%29%20699-6641> - cell* > *(888) 460-2867 <%28888%29%20460-2867>* > *www.aeonsolar.com <http://www.aeonsolar.com/>* > > > _______________________________________________ > List sponsored by Home Power magazine > > List Address: [email protected] > > Change email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out participant bios: > www.members.re-wrenches.org > > >
_______________________________________________ List sponsored by Home Power magazine List Address: [email protected] Change email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out participant bios: www.members.re-wrenches.org
