Ray:
I have to respectfully disagree with your semantics. A flashing is an overlapping of roofing materials such that gravity will direct rain and melt water off of the roof. This is a universally accepted waterproofing method that does not depend on any sealant material. The concept is as ancient as the first, crude, thatched roof. If you place a flat object on top of roofing without an uphill material lapping over the downhill object, you are not flashing. What you have described is sealant-dependent weatherproofing. Regardless of the quality of the sealant, or lack thereof, I don't think you can call it a flashed attachment. (The overarching point is a flashed attachment does not depend on a sealant. Any sealant has a finite lifespan. Removing the sealant variable from the equation results in more lasting installation.) Sincerely, William Miller Gradient Cap_mini Lic 773985 <http://www.millersolar.com/> millersolar.com 805-438-5600 From: RE-wrenches [mailto:[email protected]] On Behalf Of Ray Walters Sent: Friday, August 07, 2015 10:34 AM To: RE-wrenches Subject: Re: [RE-wrenches] to flash or not to flash My opinion is that if the L foot has enough surface area it constitutes a flashing, and that large flashings can actually cause more damage to the roof than they prevent. I also agree that an attachement doesn't constitute a penetration. I just finished an install on a metal roof with hundreds of screw holes. We added a few more screw holes, and ours have 20 times the sealant surface area. We did run a 1" conduit through the roof, and since it was an actual penetration, we used a very expensive flexible boot flashing. Personally, I think we need about a 3"x3" or 4" x 4" L foot with a double stick butyl tape on the bottom, and all will be well. I realize that the OP was referring to asphalt, but I will flash other roof types that don't do well with L feet ( like shake).
_______________________________________________ List sponsored by Redwood Alliance List Address: [email protected] Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/[email protected]/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
