Hi William Yes downsizing breaker to meet load is no problem. And getting wire that big into it with 1” KO is a pain.
I’m pretty sure any hub will work, needs 3S mate Where in the manual did you find the “don’t mix with other 60/80 controllers? Jay Peltz power > On May 15, 2020, at 12:46 AM, William Miller <will...@millersolar.com> wrote: > > > Friends: > > I have occasion to try the FM100 charge controller. I am wondering of anyone > had found any quirks with implementing this device. I have a few specific > questions: > > 1. I want to avoid AFCI unless mandated. Will this be defeated if I don’t > run the leads through the sense coil? (There is an AFCI and non-AFCI version > but I can’t seem to find the non-AFCI version anywhere.) > 2. I noticed the manual indicates you are not supposed to mix the FM100 > with the FM80 or 60 in the same battery system. This negates it for one > project I had in mind. I am curious as to why this is. Anyone know? > 3. Will the FM100 work with a standard hub? > 4. I suppose this unit requires a 125 amp breaker. If the PV array cannot > support that full 100 amps I might down-size the OCPD accordingly. Anyone > contemplate this question? > > Thanks in advance. > > William > > > _______________________________________________ > List sponsored by Redwood Alliance > > List Address: RE-wrenches@lists.re-wrenches.org > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > List-Archive: > http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html > > List rules & etiquette: > www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > www.members.re-wrenches.org >
_______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org
