It has a Combox and I was able to check the system using the web interface on the local network. There were no faults at the time I was there, but there was an OverTemp warning. I have not personally observed it with the F66 error, so I don't know anything else, but it stands to reason that eventually the warning reaches the level of a fault/error. I'm going to see what happens with the Inverter and Charger functions disabled. If it faults out again, I will just delete it from the system.
Thanks, everyone, for the help. I'll report back if I learn anything else. Jason Szumlanski Principal Solar Designer | Florida Solar Design Group NABCEP Certified Solar Professional (PVIP) Florida State Certified Solar Contractor CVC56956 Florida Certified Electrical Contractor EC13013208 On Thu, Jun 13, 2024 at 11:41 AM Dave Angelini Offgrid Solar via RE-wrenches <[email protected]> wrote: > Going out the door. > > If the bad inverter is the master. You will need to assign a new master. > Since this is 1st generation XW you will need to use SCP and probably use > the manual if you are not familiar. Rebuild the xanbus network. > > That is alot of loading and the usual warnings about heat killing > electronics and the need of cooling down your way. Good Luck! > > > > > *Dave Angelini Offgrid Solar > "we go where powerlines don't" > <http://members.sti.net/offgridsolar/>https://offgridsolar1.com/ > <https://offgridsolar1.com/> <http://members.sti.net/offgridsolar/> > e-mail [email protected] <[email protected]> > text 209 813 0060* > > > On 2024-06-13 8:26 am, Dave Angelini Offgrid Solar via RE-wrenches wrote: > > Disco 250A breaker on bad XW and remove its xanbus RJ45. Assume the bad > one is not the master? > > > > *Dave Angelini Offgrid Solar > "we go where powerlines don't" > <http://members.sti.net/offgridsolar/>https://offgridsolar1.com/ > <https://offgridsolar1.com/> <http://members.sti.net/offgridsolar/> > e-mail [email protected] <[email protected]> > text 209 813 0060* > > > On 2024-06-13 8:01 am, Jason Szumlanski via RE-wrenches wrote: > > I'm looking at an off-grid quad inverter setup for a client, not my > installation. One of the stacked.inverters is extremely hot, sometimes it > goes into F66 and takes down the adjacent inverters with it to F66 probably > because of these Xanbus network is broken. > > I disabled charging and discharging on the inverter that is getting hot, > but it's still remains very hot. Any ideas? > > I tried to put that one inverter in standby, but the generator will not > sync with the remaining three and charge the batteries. So I have to leave > it in normal operating mode for the moment. > > Jason Szumlanski > Florida Solar Design Group > > _______________________________________________ > List sponsored by Redwood Alliance > > Pay optional member dues here: http://re-wrenches.org > > List Address: [email protected] > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > There are two list archives for searching. When one doesn't work, try the > other: > https://www.mail-archive.com/[email protected]/ > http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org > > List rules & etiquette: > http://www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > http://www.members.re-wrenches.org > > > _______________________________________________ > List sponsored by Redwood Alliance > > Pay optional member dues here: http://re-wrenches.org > > List Address: [email protected] > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > There are two list archives for searching. When one doesn't work, try the > other: > https://www.mail-archive.com/[email protected]/ > http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org > > List rules & etiquette: > http://www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > http://www.members.re-wrenches.org > > _______________________________________________ > List sponsored by Redwood Alliance > > Pay optional member dues here: http://re-wrenches.org > > List Address: [email protected] > > Change listserver email address & settings: > http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org > > There are two list archives for searching. When one doesn't work, try the > other: > https://www.mail-archive.com/[email protected]/ > http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org > > List rules & etiquette: > http://www.re-wrenches.org/etiquette.htm > > Check out or update participant bios: > http://www.members.re-wrenches.org > >
_______________________________________________ List sponsored by Redwood Alliance Pay optional member dues here: http://re-wrenches.org List Address: [email protected] Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org There are two list archives for searching. When one doesn't work, try the other: https://www.mail-archive.com/[email protected]/ http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org List rules & etiquette: http://www.re-wrenches.org/etiquette.htm Check out or update participant bios: http://www.members.re-wrenches.org
