My installation did the same...
Upon rebooting, I had my old kernel boot, which completely messed up all
modules,
edited lilo.conf,
/sbin/lilo
rebooted,
depmod,
couple more reboots,
finally started working correctly.
RH7.0 broke my x ...still haven't gotten it back up yet,
I can't recompile the kernel...
bugs..bugs..bugs..
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Craig Kelley
Sent: Tuesday, October 03, 2000 10:50 AM
To: Red Hat Devel List
Subject: Re: RHL 7.0
On Sat, 30 Sep 2000, Ivan Jager wrote:
> I finally finished downloading Red Hat Linux 7.0. I repartitioned my HD
and did a complete install.
>
> During the installation one thing I noticed was that every time I
> pressed F1 it would say the help for that was not available. Is that
> only because I was doing an FTP install? I remember RHL 5.2 had help.
> The help for the packages was especially useful.
I noticed this as well.
Some other observations: I upgraded my pinstripe which had
kernel-2.2.16-17. RedHat 7.0 installed kernel-2.2.16-22 but anaconda did
not run lilo (even though I remember saying 'linear' mode and all). So, I
had to use the rescue disk to get it up (kudos to the new FTP
rescue!). The fstab had been modified; there was only one kernel image in
there where once there was three; but it looked like this:
image=/boot/vmlinuz-2.2.16-16
label=linux
read-only
root=/dev/sda2
initrd=/boot/initrd-2.2.16-22.img
strange, eh? A quick edit fixed the situation.
--
The wheel is turning but the hamster is dead.
Craig Kelley -- [EMAIL PROTECTED]
http://www.isu.edu/~kellcrai finger [EMAIL PROTECTED] for PGP block
_______________________________________________
Redhat-devel-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-devel-list
_______________________________________________
Redhat-devel-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-devel-list
