I'm trying to install RH5.0 on a P166 w/ 32M ram and the RH Install refuses
to find either NIC.
Both NICs are 3COM's 3C905B-TX (10/100BASE-TX). I checked the HW Compat.
list and as
far as I can tell this card is supported. When I used a dos sys disk to run
3COM's config util.
I had no problem finding both cards. I set one at irq 5 and i/o addy 0240
and the other at
irq 10 and i/o addy 0340 with no probs. When I rebooted and started the RH
install all went
well until it tried to find the NIC's. I kept getting a not found response.
I tried using only one NIC
as well as both NIC's during the setup with no luck. I'm at a loss. I've
queried the resident
LINUX gurus here and they had no luck either. We need to make this work so
we can setup a
proxy to "protect" our users.
Any help would be greatly appreciated.
Thanks,
Joseph McGuirl
J & J Communications
http://www.jjcom.com
PO Box 50651
Henderson, NV 89016
winmail.dat
