Peer not authorized to use remote address

[Riley, Patrick \(Patrick\)** CTR **]

Hi,

I'm hoping someone can help me out here.  I thought I had it figured out on
6.1 but I just installed 6.2 and it's all starting over again.  Right after
the install, I went in X and set up kppp but when I try to connect, I get
something similar to:
(sorry I don't have the exact message but I had to send this from a machine
that could connect)
******************************
pppd2.3.11 started by root, uid0
" " " "
" " "
peer is not authorized to use remote address xxx.xxx.xxx.xxx.
connection terminated.
connect time 0.1 minutes
exit
******************************
I found something in a newsgroup about maybe the default route is into the
LAN and that pppd needs to have it set to my ISP.  If I remember correctly,
the only way I had it working with 6.1 was when I didn't set anything up
with my NIC and during this recent install to 6.2, I specified all of that
during setup.  Could this be the problem?  And if so, what would be the best
way to go about fixing it?  Any information would be greatly appreciated
because this is becoming more than a full-time project.  

Thanks in advance,
Patrick


-- 
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.