David,
I had this same problem. You most likely have the BIOS set for LBA, try setting it to
CHS and see if that
works. It did for me. I did a completely new install after the change, it does not
mean you do. I had wiped the
drive clean because I was not sure what had happened.
Good Luck..
*********** REPLY SEPARATOR ***********
On 6/16/2000 at 4:35 PM David Williams wrote:
>I upgraded my hard drive recently and when I went to reboot from
>the new drive lilo fails. It gives me "LI" and hangs. I've been
>digging through the docs and it says that this could mean a drive
>geometry mismatch. Makes sense since it is a larger drive.
>Creating a boot disk gives the same results. I have a boot disk
>from another system boots but it uses an older kernel. I'm still
>trying to dig through the docs but can anyone tell me how to "fix"
>lilo?
>
>Thanks.
>
>
>-----
>David Williams - Computer Packrat
>[EMAIL PROTECTED]
>http://www.trailingedge.com
>
>
>--
>To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
>as the Subject.
--
To unsubscribe: mail [EMAIL PROTECTED] with "unsubscribe"
as the Subject.
