I can only think of one fix: change the order of
execution for your start-up scripts:
/etc/rc.d/rc3.d,rc5.d/S10network@
#change the '10' to a number greater than '45' so that
it will get executed *after* the pcmcia script below.
/etc/rc.d/rc3.d,rc5.d/S45pcmcia@
Hope this helps,
L.G.
On Tue, 5 Sep 2000, Bruce Kall wrote:
> I just upgraded from kernel 2.2.14 to 2.2.16 using the RH RPM's under
> RH6.2.
>
> Now I have to rerun the network startup script to get my network
> runing. Under 2.2.14 it would run the network script and Fail
> since my network card is a pcmcia card, but would delay the init
> of eth0 and it would eventually would come up fine. Now the
> network scipt fails, it delays init of eth0, but the network does
> not actually come up until I rerun the network script. I do not
> see any new initscripts, so have anybody else seen this and have
> a fix?
>
> Thanks,
> Bruce
>
> --
> ====================================================================
> Bruce Kall
> Mayo Foundation
> Rochester, MN
>
> e-mail: [EMAIL PROTECTED]
> phone: (507) 255-4768
>
> ====================================================================
>
>
>
> _______________________________________________
> Redhat-list mailing list
> [EMAIL PROTECTED]
> https://listman.redhat.com/mailman/listinfo/redhat-list
>
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
