Sure. One way that caluerpa reproduces is by going asexual. Is what happens is it releases all of its chloropyll into the water column and dies. Some times an aquarist will wake up in the morning, and their tank water is very very cloudy and their caluerpa is white (and dead). That is because it went asexual and dumped all of its chloropyll. It is not a good thing for your tank, and kills the caluerpa.
Shane > -----Original Message----- > From: Marco Delsordo [SMTP:[EMAIL PROTECTED]] > Sent: Monday, October 01, 2001 10:13 AM > To: [EMAIL PROTECTED] > Subject: RE: Carbon > > Thanks Shane, as for caulerpa, I�ve never seen that taxfolia species, i�ve > seen Racemosa, Prolifera and Floridiana, i was planning to add some of > that > species depending what is on my lfs, right now they have some of what is > like a feather form. > And of that a sexual thing i didn�t knew what was it, could you explain it > to me a little more? > Thanks > Marco > > > > > > -----Original Message----- > From: Shane Clays [mailto:[EMAIL PROTECTED]] > Sent: Lunes, 01 de Octubre de 2001 10:54 a.m. > To: '[EMAIL PROTECTED]' > Subject: RE: Carbon > > > Marco, > > Your photoperiod should be at least 12 hours, just like your reef. When > you > light it is up to you. You can go longer if you want, but I would not go > less. As far as the species, they are all somewhat sensitve. There is one > that has a common name of sawblade caluerpa. It is said to be the only > species that takes tons of abuse without going asexual. The key to keeping > that from happening with the other species is to cut it back regularly. If > you cut it back once a week or two, it is much less likely to go asexual, > no > matter what the species. > > Now, there is a species which you DO NOT want to get. It is caleurpa > taxfolia. It is a toxic form of caluerpa and will kill any animals that > eat > it. If a piece happens into your display, and a fish eats it, it will kill > the fish. No caluerpa is better than this stuff. > > As for planting, you can just plop it in the tank. You dont have to plant > it. It will just take off and grow. A piece of LR with some attached is > nice, because you have some control over where the stuff grows from, but > it > is not neccesary. Salinity could be raised a bit, and should be .023ish. > > To remove the yellowing water, run carbon. You can run it for a few days a > month to keep the yellowing agents in the water at a minimum. Do water > changes as well. That will help. It will also help your tank stabilize > after > removal of your bio balls and fluidized filter. > > FWIW > Shane C. > > > -----Original Message----- > > From: Marco Delsordo [SMTP:[EMAIL PROTECTED]] > > Sent: Monday, October 01, 2001 8:37 AM > > To: [EMAIL PROTECTED] > > Subject: Carbon > > > > Hi all, it�s been quite a long since my last annoying question, so here > is > > another. > > I finished setting up my 10 gal refugium, with a fine crushed coral > > substrate (almost like sugar or a little bit larger size) of about 2 - 2 > > 1/2 > > inch deep, it is connected to my sump via a pvc tube and then with a > power > > head back to the sump. > > I want to add the caulerpa now, but i don�t know which kind is the > > hardiest > > and how to plant it. Or should i just add live rocks with caulerpa on > it? > > will this be easier? > > Also, how do I take care of it?, how long the photoperiod should be? any > > comment about algae care? My salinity is 1.020, will i have to increase > it > > for the algae or the open brain coral? > > And another question, i removed my carbon from the tank about 1 month > ago > > because people says it does more damage than good in my tank, but now > the > > water is kindda yellow, how do i get rid of it? > > Also, Shane, I followed your advice and removed in a period of 5 or 6 > days > > all my bioballs and fluidized bed filter from the tank, hope this helps > to > > lower my nitrates and also I won�t have ammonia or nitrite outbreaks. > > Thanks all for your advice. > > Marco > > > > ________________________________________ > > > > LEAVING THE LIST > > ===============To stop receiving messages you will need to send a > message > > to [EMAIL PROTECTED] with a command to remove you from > the > > list. The list manager controls who belongs to the list. > > > > For example: > > -------------------------------------------------------------- > > From: John Doe <[EMAIL PROTECTED]> > > To: [EMAIL PROTECTED] > > Subject: <not needed> > > > > UNSUBSCRIBE > > -------------------------------------------------------------- > ________________________________________ > > LEAVING THE LIST > ===============To stop receiving messages you will need to send a message > to > [EMAIL PROTECTED] with a command to remove you from the > list. > The list manager controls who belongs to the list. > > For example: > -------------------------------------------------------------- > From: John Doe <[EMAIL PROTECTED]> > To: [EMAIL PROTECTED] > Subject: <not needed> > > UNSUBSCRIBE > -------------------------------------------------------------- > ________________________________________ > > LEAVING THE LIST > ===============To stop receiving messages you will need to send a message > to [EMAIL PROTECTED] with a command to remove you from the > list. The list manager controls who belongs to the list. > > For example: > -------------------------------------------------------------- > From: John Doe <[EMAIL PROTECTED]> > To: [EMAIL PROTECTED] > Subject: <not needed> > > UNSUBSCRIBE > -------------------------------------------------------------- ________________________________________ LEAVING THE LIST ===============To stop receiving messages you will need to send a message to [EMAIL PROTECTED] with a command to remove you from the list. The list manager controls who belongs to the list. For example: -------------------------------------------------------------- From: John Doe <[EMAIL PROTECTED]> To: [EMAIL PROTECTED] Subject: <not needed> UNSUBSCRIBE --------------------------------------------------------------
