Wow, sounds like the pH problems are due to too much output from the
reactor. So, I will slow that down immediatly. I guess just go from
there....
Thanks,
Shane
> -----Original Message-----
> From: [EMAIL PROTECTED] [SMTP:[EMAIL PROTECTED]]
> Sent: Friday, October 05, 2001 12:54 PM
> To: [EMAIL PROTECTED]
> Subject: Re: Calcium Reactor Update and Questions
>
> Shane,
> I just set up a calk reactor...the suggested drip rate into the tank is 40
>
> drops/min I think that would fall far short of 3/4 gph! The pH in the
> calk
> should be 6.4 with the CO2 injecting! The bubble rate on the CO2 is 1
> every
> 5 sec. There is no white color in the tubes!
> jcd
> ________________________________________
>
> LEAVING THE LIST
> ================
> To stop receiving messages you will need to send a message to
> [EMAIL PROTECTED] with a command to remove you from the
> list. The list manager controls who belongs to the list.
>
> For example:
> --------------------------------------------------------------
> From: John Doe <[EMAIL PROTECTED]>
> To: [EMAIL PROTECTED]
> Subject: <not needed>
>
> UNSUBSCRIBE
> --------------------------------------------------------------
________________________________________
LEAVING THE LIST
================
To stop receiving messages you will need to send a message to
[EMAIL PROTECTED] with a command to remove you from the list. The list
manager controls who belongs to the list.
For example:
--------------------------------------------------------------
From: John Doe <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED]
Subject: <not needed>
UNSUBSCRIBE
--------------------------------------------------------------
