right now I am lock out did you have to do a cold boot on the controller to reset it? I have been doing this remotely thanks VA3VKK Kim
----- Original Message ----- From: "Steve S. Bosshard (NU5D)" <[EMAIL PROTECTED]> To: <Repeater-Builder@yahoogroups.com> Sent: Sunday, November 16, 2003 12:33 PM Subject: Re: [Repeater-Builder] RC-1000 Controller > on programming commands with an D like D14 to enable programming the cwid, > do not enter the D. > > Also commands with #, like #9 to force ID, enter 09 and do not enter #. > > Had the same challange last Thursday. Once programmed really works > well. > > ssb > > ----- Original Message ----- > From: "va3vkk" <[EMAIL PROTECTED]> > To: <Repeater-Builder@yahoogroups.com> > Sent: Sunday, November 16, 2003 8:26 AM > Subject: [Repeater-Builder] RC-1000 Controller > > > | RC-1000 Controller by Micro Computer Concepts > | Unable to gain access after I enabled the programing control 1 & 2 > | > > > > > > > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/ > > Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/