ok , ive spent the last 8 hrs now bouncing back and fourth between
the pc here and this GD(*&^# , RC-1000V , im about fed up with its tech
support in flordia too , has anyone else messed with programming it
through the radio , im convinced now the COS isnt tripping the
controller , it says tie high 2-30 volts ,and tie low 0.0 - 0.5
volts , but holy hell , i just cant seem to get the micro computer in
the controller to respond tothe dtmf , and it wount reset by grounding
pin & 7 now , so i have a $200 Cigar ash box ....... and further
more what is this Hex to Dec conversion table the manual keeps refering
to , its not a starndard one cause 3C = 60 and if it goes by 10
sec intervals thats 10 min not 8 min and 8 min is 48 or 30 in hex ,
so where doed his hex chart fit in , im really getting lost and am
almost tothe point to not recomend this product to anyone else
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
