I tried this on the IC-H16 it worked for this model but for IC-H16T it did not. I think it has a different access code. The H16T is still working with the previous frequencies I use, so I did not reset the CPU. Thanks for your support in this.
Joey >From: Virden Clark Beckman <[EMAIL PROTECTED]> >Reply-To: [email protected] >To: [email protected] >Subject: Re: [Repeater-Builder] ICOM H16T ACCESS CODE >Date: Mon, 05 Apr 2004 00:43:25 -0400 > >Hold down the func key on the side the entire time you press the 6 >numbers on front, i don't have the manual handy but once you are in >program mode use the up/down arrows to change channels - 5 shows the rx >- i think 7 shows the offset, plus or minus or nothin - pl uses a code >and you'll need the manual for those numbers unless you have that >memorized, if you still get nowhere, open the radio and apply power with >jumper wires to the bottom spring things and reach into the pc board >behind the screen with a plastic popsickle stick and push that black >button when applying power to erase all the memory status. reassemble >the radio and reprogram everything including the scan features. > >Joey Diaz wrote: > > > > I tried 1 5 9 3 5 7 but nothing happened > > > > >From: Johnny <[EMAIL PROTECTED]> > > >Reply-To: [email protected] > > >To: [email protected] > > >Subject: Re: [Repeater-Builder] ICOM H16T ACCESS CODE > > >Date: Sat, 03 Apr 2004 22:32:19 -0800 > > > > > >I think it should be, 1 5 9 3 5 7 > > >Johnny > > > > > > > > >Virden Clark Beckman wrote: > > > > I have a u16, to get to program hold the f key on the side and press > > > > 1,5,9,7,5,3 then turn off and on to go back to run the radio. > > > > > > > > Joey Diaz wrote: > > > > > > > >>Hi, > > > >> > > > >>I have an old ICOM IC-H16T. I have not used this unit for a long >time. > > >I > > > >>would like to ask for assistance regarding the access code for this > > >radio so > > > >>I can program other frequencies I would use in a local repeater. I > > >would > > > >>highly appreciate is someone can provide me the access code with the > > > >>steps/procedure for this radio, I have already removed the >lock/jumper > > >pin, > > > >>I only need the codes. > > > >> > > > >>Thanks and Regards, > > > >> > > > >>Joey > >-- >73...Clark Beckman N8PZD > > > > > >Yahoo! Groups Links > > > > > _________________________________________________________________ The new MSN 8: smart spam protection and 2 months FREE* http://join.msn.com/?page=features/junkmail Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
