Jeff, Just the answer I was looking for! Thanks Jeff!!
Adam N2ACF ----- Original Message ----- From: "Jeff Otterson" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Saturday, April 17, 2004 6:19 PM Subject: Re: [Repeater-Builder] NHRC 4/M2 Remote Base Audio > Hi, > > The remote base receiver audio input on the NHRC-4/M2 is set up for > de-emphasized audio as shipped. > > If you want to use discriminator audio and de-emphasize on the > controller, you need to change R19 to 510 K, change R20 to 51K, and install > a .0068 uf cap in location C10. See page 2 of the schematic. > > Regards, > > Jeff > > > At 05:43 PM 4/17/2004, you wrote: > >Hello All, > > > >Today, I fed the remote base receive audio input of an NHRC 4/M2 with > >descriminator audio from a Motorola Maxtrac. I'm taking the audio right from > >the 16pin accy plug on the radio. When listening to the primary port of the > >controller, the remote base audio seems a "bit" high pitched and not rolled > >off enough. > > > >Has anyone else experienced this on this controller or perhaps I'm doing > >something wrong? > > > >Any help would be greatly appreciated. Thanks! > > > >Adam N2ACF > > > > > > > > > > > > > > > >Yahoo! Groups Links > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
