Re: [Repeater-Builder] 7K to MastrII Repeater Backplane

[Steve Grantham]

run that wire up to the exciter... if it is a duplex station, run it to the black exciter plug on the door/drawer, and then to the appropriate pin on the exciter..  if it's a transceive station combination, a wire may already be run from the receiver system board (where the cg board plugs in) to the exciter..  channel guard mod does not normally appear on the backplane.  if a mobile conversion, look for a trace on the system board that connects to the cg mod pin on the exciter.  it doesn't PL..  hi hi!  :)   Steve  ----- Original Message ----- From: Adam C. Feuer To: Repeater-Builder@yahoogroups.com Cc: [EMAIL PROTECTED] Sent: Tuesday, September 21, 2004 7:51 PM Subject: [Repeater-Builder] 7K to MastrII Repeater Backplane Hello All,   I'm about to install a 7K onto a MastrII repeater. I have found all of the points on the backplane that I need via the documentation at the Scom resource page "Interfacing a 7K to a GE MastrII."   However, I'm at a loss for one point and do not see it on that resource page.   I will be using a TS-64 through the 7K , not a factory Channel Guard Board.    Where on the backplane can I inject the PL once it comes out of the 7K?  Does "Channel Guard Input" appear on the backplane or must I run that wire up to the exciter?   Any help would br greatly appreciated!   Thanks   Adam N2ACF Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/   To unsubscribe from this group, send an email to: [EMAIL PROTECTED]   Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.