Kevin, That surprises me, because I have several DVP stations of the same model, and all worked with the jumpers I described. A few questions come to mind:
1. Have any traces been cut or bridged on the DVP backplane? 2. Are the SCM, TOT, and SG modules absolutely "stock" with no modifications? 3. Are there additional jumpers on the backplane besides the jumpers I specified? 4. Did the repeater operate properly in DVP clear mode before you acquired it? 5. When you say "no repeat function" do you mean that the transmitter does not come on when a correct input signal is received, or do you mean that the transmitter does come on but without repeated audio? Check to ensure that the TLN5970A Station Control Module is suffix "-2" or later, if you are using a TRN8684A Timeout Timer Module. If the SCM is earlier than suffix -2, you MUST use only the TLN4636A TOT module. This tidbit of information is in SMR-3638-1. Don't forget to program the jumpers in the TLN4662A Squelch Gate Module per the chart in the manual. Use the settings shown for a repeater (RT) station without wire line control. Finally, ensure that the PA keying wire that plugs into the left side of the PA is also plugged onto Pin 10 on the rear of the backplane. 73, Eric Lemmon WB6FLY Kevin Bednar wrote: > > I have done exactly this on mine as well, but still no repeat function... > > From: Eric Lemmon [mailto:[EMAIL PROTECTED] > Sent: Saturday, October 02, 2004 1:38 PM > To: [EMAIL PROTECTED] > Subject: [Micor] Help with DVP backplane information > > Steve, > > I have a C73RXB3106BT in my shop right now, and it is working fine. It has > the DVP backplane TLN5979A, which requires the following jumper arrangement: > > JU2, JU4, JU5, and JU7 must be IN. JU4 is a diode, with the cathode bar on > top. > All other jumpers must be OUT. > On the back of Slot 10, the CD slot, jumper pin 7 to 15, and pin 10 to 17. > > You must use a TLN5970A Station Control Module in Slot 2. Install a Timeout > Timer Module in Slot 3 and a Squelch Gate Module in Slot 6. Remove all other > modules from the chassis. Note that the TOT and SG > modules are the same between DVP and non-DVP stations... > shschampion wrote: > > > > I'm pleased to report that my C73RXB3106BT seems to be close to working on > > Two Meters... > > Can anyone help with the specific backplane information that I need?... Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
