Doug, We talked before on these amps, if possible I would like you to hold a couple for me and would not mind sending a little money as I can. Since I was laid off I have had to cut my Ham budget way down. Let me know what you think. I am in the process of coordinating two 900 MHz repeaters here in the area and have GE equipment I am going to modify but have don't have any good PA yet.
Thanks, Paul -----Original Message----- From: Doug Bade [mailto:[EMAIL PROTECTED] Sent: Friday, December 03, 2004 11:55 AM To: [email protected] Subject: Re: [Repeater-Builder] Ho! Ho! Ho! I have some GE Mastr III 860 amps, which I am selling, which are rated at 110w on 26-28vdc.. +10dbm drive. They make 100 or better on 927.9875 and below. Most do 110w. Size is comparable to a Mastr II station PA. Asking what I consider to be quite reasonable.... The Maxtrac Exciter is +20dbm at the pin coax.... email me at [EMAIL PROTECTED] for more info... Doug KB8GVQ At 12:44 PM 12/3/2004, you wrote: >Wouldn't that be Yo! Yo! Yo! <G> > >Anyhow back on the topic of repeaters...... >I lurk quite a bit here and over on the AR902 group and I am in the >process of gathering the pieces >and parts to put up a 900Mhz amateur repeater. I am trying to locate a >relatively inexpensive >900 Mhz continous duty amp to be driven by a Maxtrac exciter as well as a >source for a duplexer. > >I already have the maxtracs for use and the filters. I just need to do >the VCO mods , replace the filters, >and build my interface between the units. I have access to heliax and a >900mhz commercial repeater antenna >for use...maybe even two. > >Any recommendations on where to find the amp and duplexer on a budget ? > >73, >Jon >KD5SFA Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
