If there is one opening on the top plugged, you've likely got the vari-notch 
configuration. The other opening should have two N connectors and the notch 
tuning cap.

Chuck
WB2EDV



----- Original Message ----- 
From: "Mathew Quaife" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Tuesday, December 28, 2004 9:33 PM
Subject: Re: [Repeater-Builder] TX RX Duplexer


>
> There is still plenty of tuning rod left, I would say it should go, but 
> hard
> to tell much more about it than that.  I looked on the website, but pics 
> of
> them to go by.  These can's are about 6.5" in Diameter and about a foot
> high, with two tuning knobs on the top of them.
>
> Mathew
>
>
>>
>> At 12/28/2004 06:00 PM, you wrote:
>>
>>
>> >Anyone have any idea how to identify a set of TX-RX duplexers for
>> >the 450 band if there is no tags on it.  The setting of the freq
>> >that was written on them is 456.150. Any help would help.
>> >
>> >Thanks.
>> >
>> >Mathew
>>
>> If that freq. was stamped by the factory, it should tune down to 440 MHz
>> with no mods or cable changes.
>>
>> Bob NO6B
>>
>>
>>
>>
>>
>>
>>
>> Yahoo! Groups Links
>>
>>
>>
>>
>>
>>
>>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
> 






 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




Reply via email to