Mathew, I don't remember exactly what the problems were with your
earlier posts, but I understand that you have an adjacent channel user
with 9kc deviation, right?  If so, then cavity filters will have
absolutely no effect.  The passband of even large cavities is far
wider than the 15 or 20 kc of spacing you are dealing with here.  It
sounds like the preamp you added is simply (obviously) pushing more
signal from the offending transmitter into your receiver, making it
more susceptable to the offender.  The real culprit here is the wide
transmitter.  No amount of tuning or selectivity (except maybe crystal
filters???  I've never used them) ahead of your receiver will reduce
the offender.  Narrower IF filters within your receiver may help, but
there are practical limits to that. 

Laryn K8TVZ 
 


--- In [email protected], "w9mwq" <[EMAIL PROTECTED]> wrote:
> 
> Everyone remembers my problems I had with a neighbor about 26 miles 
> away getting into my repeater on the input with his 9Khz wide 
> transmitter, which the GE MASTR receiver took care of that, but I 
> just installed a ARR preamp, and he is back, and I think I tuned 
> them correctly, the DB-4001-2 Filters.  Antenna is up at 90' and can 
> be accessed about 25 miles away with a Handi-Talki using a rubber 
> duck.  So the receive is good, but to good.  And I know the problems 
> with preamps, but was hoping the filters would prevent that.  Any 
> thoughts.  I am getting no decense on the receiver that I can 
> detect, and that is with the two hundred watt pa running.  Any ideas 
> other than removing the preamp back out of line, and yes I am 
> planning a letter to the Ham causing interference.
> 
> Mathew







 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




Reply via email to