Thanks Bob,

The receiver is the Mastr ER41 series receiver.  My receive is at 146.925
and the other repeater that is about 50 miles away receives at 146.310.
Generally we don't have a problem, and did not after I put the GE receiver
in, until I put the preamp on.  Before the preamp was installed, I could key
up with 250 watts on 146.310 and never key up the repeater, both just feet
away from each other.  I will try the 10 db pad and see if that takes care
of it without degrading the receive senstivity.  Thanks for the tip.

Mathew

----- Original Message -----
From: "Bob Dengler" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Monday, January 10, 2005 10:43 AM
Subject: Re: [Repeater-Builder] Filters on Receive Side, how do I know if
they are working?


>
> At 1/9/2005 10:24 PM, you wrote:
>
> >Mathew,
> >
> >When considering RF preamp gain, more is not always better.  I'm not
> >familiar with the ARR preamp, but if it is a GaAsFET amplifier with 17
> >dB or so of gain, and your bandpass cavities have 1.5 dB of insertion
> >loss, I would put either a 6 dB or a 10 dB coaxial attenuator on the
> >output of the preamp.  A net gain of 6 to 10 dB is usually enough to
> >improve sensitivity without overloading the existing RF amplifier or
> >mixer stages.
>
> If you're using a G.E. Mastr (which one?) RX without a preamp, the ARR
> preamp is not going to overload the G.E.'s front-end.  Adding a 10 dB pad
> to the pramp output would knock your total gain ahead of the G.E. RX down
> to 5.5 dB.  OTOH if we're talking VHF you shouldn't need much gain ahead
of
> the G.E. RX.  If we were talking UHF I'd say leave the pad out.
>
> You didn't mention which G.E. RX you're using (MASTR Pro, II,
> Exec??)?  Anything other than a Mastr II will be a bit wide for 15 kHz
> spacing.  I know in the end the 9 kHz deviated signal is the culprit, but
> if you weren't getting adjacent-channel interference before it wouldn't
> take much of an improvement in IF selectivity to lose the interference
> while keeping the improved RX coverage.
>
> Bob NO6B
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>





 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




Reply via email to