Except that RG-174 is NOT 100% shielded, and he is using a duplexer. If 
it was mounted in a metal box, and the box was grounded to the exciter 
chassis, it *might* work without causing desense...maybe.
-- 
Jim Barbour
WD8CHL

Rogers, Ron wrote:

> That's easy....just wind up about 25-30 feet of RG-174 coax and install
> that between the 2 watt exciter and the Vocom Amp. That wound up coax
> will give you about a 3 Db loss at 146 mhz and supply only 1 watt to the
> amp instead of the 2 watts.  Very simple and highly
> reliable.......nothing to break.
> 
> Ron Rogers 
> WW8RR
> 
> -----Original Message-----
> From: w9mwq [mailto:[EMAIL PROTECTED] 
> Sent: Tuesday, January 18, 2005 12:53 PM
> To: [email protected]
> Subject: [Repeater-Builder] Re: Adjacent Channel Noise, how far should
> it be heard
> 
> 
> 
> I want to say thanks to all those that replied on this matter, I 
> believe I have it fixed.  Found that the deviation had changed and 
> was running at about 6 Khz wide.  Not sure why, unless a pot had a 
> dirty spot on it.  Everything looked ok on the spectrum analyzer.  
> Someone asked why I was running so much power.  Not that I am a 
> power hog, but I took off the Motorola PA that everyone said would 
> go bad, and replaced it with a Vocom 200 watt amp, just have not 
> built a pad large enough to drop the power output.  2 watts drives 
> the PA at 200 watts.  All that will have to change when the antenna 
> goes up at 150 feet.  Again, want to say thanks for the quick 
> responses.
> 
> Mathew
> 
> 
> And yes the Diamond Antenna is only a temp setup, as it will be 
> replaced with a DB224 when the new tower goes up.





 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 




Reply via email to