Hi Mike,
The CAT controllers do not have a built-in PL Decoder and/or Encoder.
The PL setting in the controller is only used for access requirements
(ie.. is PL required to key up the repeater).
In order to change the RX or TX PL Frequency your going to have to
reference the documentation for your PL Decoder/Encoder.
Let the group know what PL board your using and maybe we can point you in
the right direction.
73,
Sean
On Tue, 1 Feb 2005, Mike - WM4B wrote:
>
>
>
> Greetings all,
>
> I've recently joined up with our club repeater guru and I'm trying to
> get smart.
>
> We need to set a temporary PL for some troubleshooting efforts (we
> have a mixing problem which causes the repeater to kerchunk itself
> continously when the transmitter output mixes with some other (as yet
> unknown) signals. Can somebody step me through this? The book only
> mentions PL back in the remote-base section, which confuzes me a bit.
>
> At any rate, we want to set the PL to 82.5 Hz, and it MUST NOT be
> retransmitted (or our troubleshooting efforts will be moot).
>
> To make things more interesting, the last time our repeater guru went
> to the site, he could not send or receive data between the controller
> and his laptop. (He was able to log in, but could not send/receive
> data.)
>
> Any thoughts? The last repeater I worked oin was only slightly more
> complicated then two native-americans sending smoke signals back and
> forth.
>
> Thanks,
>
> Mike
> WM4B
>
>
>
>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
