At 2/24/2005 11:41 AM, you wrote:

>All understood there, but the kicker is that my equipment did not interfere
>with his repeater, it was a user that is about 70 miles away that got into
>one of his remote receiver's.

Is that 70 miles from your repeater or his?

>   I'm considering the fight of staying my
>grounds, and letting the coordinator know that if my system was the cause,
>fine, but a user is the culprit, how does that affect me.

This thread is moving into frequency coordination issues which are frowned 
on here, but I will just say that his is a bit of a gray area for the 
reasons you cite.  However, the fact remains that a repeater & its user 
base are inseparable when considering system compatibility.  There have 
been many cases here in SoCal of coordinations being modified or denied on 
the basis of user-to-repeater interference.

>And answer is that I doubt very seriously that any of the remote receiver
>sites here in Indiana are coordinated.

If that is true, then I doubt your coordinator would have granted 
protection to your co-channel system in this case, since the remote RX in 
question would be uncoordinated.  At least that's how it works out here.

>   How could they be, in fact anywhere,
>that only reduces the 100 mile radius they attempt to maintain in
>coordinating repeaters.  Also, both repeaters used the same 131.8 PL.

Oh, so you were using the SAME PL as the co-channeled system?  Why not 
change it?

Bob NO6B






 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



Reply via email to