Mathew,
    I have been following this thread for a while and we are only hearing 
your side of the issue.  Since you are using a split-split, i.e, 15 khz. 
pair, I assume that yours is the newest system so it is up to you to remidy 
the aledged problems. However, if your repeater meets the Indiana guidelines 
for physical distance separation for the first adjacent channel, and you are 
operating within the terms of your coordination, then you may tell your 
coordinator to respectfully buzz off. (In Illinois the separation for 15 
khz. spacing is 40 miles. I amagine that it might be similar in Indiana.)
    As has been mentioned here before, this seems to be a user education 
problem, not a repeater problem. Of course, you need to make sure you are 
never deviating more than 5 khz.  4.5 khz. would be better. (just to keep 
this discussion technical)
    You also mentioned that you are both using the same access tone, 
(131.8?). Probably the first thing to try would be a different access tone. 
I seem to remember that in Indiana there are tones assigned by region. If 
131.8 is primary then there is probably also a secondary tone you might use.
    You should also be able to appeal the coordinator's mandate to the full 
Indiana Repeater Council if you choose.

Good luck and 73,
Al, K9SI
Board member, Illinois Repeater Assn.


   Date: Fri, 25 Feb 2005 04:47:18 -0800
   From: Mathew Quaife <[EMAIL PROTECTED]>
Subject: RE: Going got Rough, Forced to change Freq, Need Answers

No, the frequency that I am on is 146.925, and he is on 146.910, we are 15
Khz away, a user was attempting to use my repeater where his signal passes
through their repeater, he was using about 160 watts of power with a beam to
get into the system.  His signal then caused the 91 repeater to key up.
States it was getting into a remote site.  The coordinator is not budging on
this one, tells me that I am lucky that he is giving me a frequency at all
as there is none to be had.  So now for the expense of changing all the
xtals and retuning and just more work.



Mathew


 








 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



Reply via email to