ROD:
Yes, you do only have half of the "System". You need the handset cradle
portion of the control end (not the controlled end) 510 mentioned
earlier. Without it, you are SOL.
Ciao, Tony
[EMAIL PROTECTED] wrote:
> All I have is the 221 board and the board that it connects to, all in
> the factory metal box. It has connecters for the GE Phoenix SX
> radio. There is a place where another board could connect to and
> the side holders for that board. Would that be the 510N board slides
> in at? Or is the 510N board what the 221 connects to? There are no
> buttons to push and no switches to switch. It almost sounds like I
> only have half the unit.
>
> Rod
>
>
>
>
> Hello Rod:
>
> I am looking at the 221 Series Tone remote control panel pc board manual
> and it
> matches what you describe, K1 left front, LED on the left rear DS1.
> this is the 2175 decoder card. BTW this 221 series was available in
> three models.
>
> You need the Model 510N tone remote control console (like a teleset with
> intercom, mon, f1 and f2 buttons on it depending what model remote you
> have connected. I presume you have this unit.
>
> If you wish, I can xerox a copy of the Model 221 Series tone remote
> control panels, and send it to you. It is the 098-0218 Instruction
> manual. Please email me your address direct.
>
> Ciao, Tony
>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
>
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/