--- In [email protected], "WB8UJB" <[EMAIL PROTECTED]> wrote:
"I just got our new Spectrum S-7r FM repeater. I sent the Micro
Computer Concepts RC-1000v controller to them to hook up. The PL board
installed is the Communications Specialists TS-64. Spectrum hooked the
TS-64 up with a toggle switch grounding the PTT and Hangup lines to
put it in PL mode.
...
We need to be able to control this function from the field.
...
I am not able to make the controller turn off the TS-64 to allow for
carrier access to the repeater. It works fine with PL access...."
__________________________________________________
_______________________
The RC-1000V has three AUX output control lines. These can be
remotely controlled based on the controller programming. You can
connect one of these to the TS-64 to allow you to turn PL encode on
and off as desired.
If the PL decoder output is correctly connected to the RC-1000V input
- you should be able to switch between carrier access and PL access
with a single *XX code as described in the RC-1000V user manual -
section 3.6 "PL Override"
If that doesn't work, check the connection from the TS-64 output to
the RC-1000V RX COS input at P1-4.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
