|
Re>RC1000......I experienced same problem you mentioned about it accepts
the instruction by giving RR but it really didn't. I call the controller
the fortune cookie controller because it lies to me by saying it accepted the
code but it really didn't. First off, don't be afraid to do a reset on the
Micro Processor. Its a pain doing everything over again but it's good for
you because it taxes the mind. Once started, don't stop in the
programming process. There might be a little timer in there that goes to sleep
if you stop mid stream and continue a few minutes later. There are two different
resets for the micro P. When doing, leave ground lead on reset pin for few
seconds. Don't just ground it and think everything is empty. A cheat sheet is a
good idea. Again, are you sure your Table is correct for the micro P Rev you
have? He changed some codes from En/Dis to a separate sel code for En and
Dis. Ron is a very nice person. You give him a call in Florida and he will be
glad to help you. One very important thing is to be absolutely sure your Touch
Tones are correct and the encoding radio is on frequency. I have trouble
with the D codes. The controller accepts by giving the RR but it didn't really
accept it. Don't forget the 3 second or longer pause required between
Programming Enable 1 and Programming Enable 2. When programming, everything must
be perfect. If you are a little more specific I might be able to help. Am
willing to try.
Kevin I apologize for the bandwidth. If this is too
much, holler.
Gary K2UQ Trenton, NJ
Yahoo! Groups Links
|
