Thanks Neil,

I have also done that before so tried it again today.  I now have the 4 
stuck slugs removed using the drill bit method except that I stopped a 
little sooner than your description and used a dental pick to collapse the 
sides.

Still need (3)- 3/8 in  long and (1)-1/2 in long slugs to put the board back 
into service.

Anyone with spares for sale?

Larry


----- Original Message ----- 
From: "Neil McKie" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Wednesday, March 16, 2005 6:25 PM
Subject: Re: [Repeater-Builder] GE MVP mobile tuning slugs


>
>
>  Back in the 'earlier days of radio' ... that's the Motorola T44A6A
> Receiver for those of you who were around back then and can still
> appreciate those days ...
>
>  We removed the stuck slugs by using drill bits ... hand inserted
> into each slug and carefully reaming out the center.  Once that
> drill bit cleared the stuck slug, we used the next size larger
> drill bit ... until the remaining parts collapsed and fell out.
>
>  Just our successful method.
>
>  Batteries not included / your mileage may vary.
>
>  Hope this helps,
>
>  Neil - WA6KLA
>
>
> Larry Lockard wrote:
>>
>> Sorry all .... Should have said it was a mobile...I forgot GE was dumb
>> enough to give the same designation to different types of radios.
>>
>> Also the 4 slugs are not only stripped but if like the others on the 
>> board
>> that I did get loose these will be stuck ....  tight. Pointers before I
>> replace them gladly accepted.
>>
>> I would consider buying a whole radio depending on the price or just 
>> another
>> exciter board or if someone has a spare.... GE Custom MVP UHF Mobile - 
>> board
>> needs to be capable of moving to 444 mhz area of the ham band (no tripler
>> please). As I say I'm going to duplex it and I've told to avoid the 
>> tripler
>> versions.
>>
>> Thanks
>> Larry
>> ----- Original Message -----
>> From: "Q" <[EMAIL PROTECTED]>
>> To: <[email protected]>
>> Sent: Wednesday, March 16, 2005 9:59 AM
>> Subject: Re: [Repeater-Builder] GE MVP tuning slugs
>>
>> >
>> > MVP handheld or is it a Custom MVP mobile? I have had some luck with
>> > carefully drilling out the old slugs and replacing them on Custom 
>> > MVP's.
>> > It may be less work to just get another exciter board and change it 
>> > out.
>> > They are certainly cheap enough.
>> >
>> > Paul Finch wrote:
>> >
>> >> Larry,
>> >>
>> >> If I remember correctly that hand held radio has modules, have you
>> >> taken the exciter out and tried to turn the slugs out from the other
>> >> side?  Normally only one end of the slug is stripped.  Remember, it's
>> >> been 20 years since I worked on one of those radios.
>>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
> 





 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/Repeater-Builder/

<*> To unsubscribe from this group, send an email to:
    [EMAIL PROTECTED]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/
 



Reply via email to