Thank you sir, that took care of it, right back were it should be. Now onto the power issue.
Mathew -----Original Message----- From: Q [mailto:[EMAIL PROTECTED] Sent: Tuesday, April 05, 2005 4:08 PM To: [email protected] Subject: Re: [Repeater-Builder] Pl Audio from a Cat1000B and TS64 Turn up the transmitter audio pot,turn down the CAT tx level till its happy. Mathew Quaife wrote: >I oops'ed on that one, my figures are wrong, tis what I get for not looking. >Anyways, take that down to .008 and .13. Yes, it's about a 1/3 of what it >used to be, and so long as the user of the system has a mild to soft spoken >audio it works just fine, but if they hit beyond 3.2 Khz deviation it begins >to clip. This move has really made me work this system out. > >Mathew > > >-----Original Message----- >From: Gary Laforce [mailto:[EMAIL PROTECTED] >Sent: Tuesday, April 05, 2005 3:06 PM >To: [email protected] >Subject: RE: [Repeater-Builder] Pl Audio from a Cat1000B and TS64 > > >PL tone should be run at or around .55 to .7 KC anyway sounds like its >working fine to me at 1.3KC you can hear the PL tone. Adjust to .65 KC >and call it good > > >Gary LaForce >Chariton Valley TriStar Communications >Columbia Service Department Supervisor >573.441.2224 Direct Shop line >573.442.1147 Main Business Line >573.449.8310 Shop Fax line >[EMAIL PROTECTED] > > >-----Original Message----- >From: w9mwq [mailto:[EMAIL PROTECTED] >Sent: Tuesday, April 05, 2005 1:51 PM >To: [email protected] >Subject: [Repeater-Builder] Pl Audio from a Cat1000B and TS64 > > > >Can anyone tell me, I am using a TS-64 tone board wired directly into >the cat1000B controller, and for some reason the output of the tone is >very weak, and that is with the pot turned all the way up. It is less >than .800 KC and used to be about 1.3 before I changed the frequency >of the repeater. Any suggestions what might have went wrong. > >Mathew > > > > > > > > > > > > Yahoo! Groups Links Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
