--- In [email protected], "w9mwq" <[EMAIL PROTECTED]> wrote:
Ok, I'm sure these duplexers are tuned correctly, but here is what is
happening. If I inject 1.5 watts into the transmit side of this
duplexer I get about 95% of that back, with about 1.4 watts from the
duplexer. Then I pump 130 watts into the duplexer and only get 60
watts back. Why such the loss with the higher power? Transmitter and
amp are both ok on a dummy load, looks good on the spectrum analyzer,
no problem there. The amp is rated 2 watts in for 200 watts out. I
put in 1.5 watts, to get the 130 watts out, that is fine. Other part
that I am confused with, the amp into a dummy load, starts out at 100
watts and then gradually creeps upto 130 watts over about 30 seconds.
Current draw on the power supply is 18 amps, from a 70 amp astron.
Could it be that the power supply is slowing giving juice to the amp,
kinda like the caps might be weak? Any thoughts?
Mathew
________________________________________________________________________
First, when you say you "get 95% of that back", I assume you are
referring to the amount of power you are measuring at the antenna port
of your duplexer for a given power you have input to the transmit port.
I suspect your measuremnet technique or instrument may account for the
difference between what you see at low power levels and what you see
at high power levels.
You should be using a "real" wattmeter such as a Bird 43. Also, to
accurately measure low power levels you should be using a low power
element, in this case a #095-2 2.5 Watt element would be ideal; a #5C
5 Watt element would be acceptable. Measuring low power levels in the
lower 25% range of an analog meter device is only going to give you an
approximation of reality.
Your high power element should be a #250C. Ideally, you would be
using two Wattmeters simultaneously. You can get a document from
Tx-Rx, TECH-AID No. 93001, titled "Measuring Insertion Loss With
Wattmeters" that will explain the entire process.
If you are really getting only 60 Watts out of your duplexer for an
imput power of 130 Watts, that represents a loss of 3.35 dB, which is
probably excessive. Your measured dB loss should agree with the
manufacturer's specifications for your duplexer model and your
alignment results.
You should investigate your other issue by placing a Wattmeter between
the transmitter [driver] and the amp. You should also have another
Wattmeter on the output. At the same time you should monitor the
power supply voltage to the amp - both DC and AC [to look for ripple
that might AM modulate your amp]
Your objective is to be sure the power supply is stable and clean and
the drive level does not change - which would then isloate the problem
to the amp itself.
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/