Do you hear output at all on the expected frequency when on a hand
held? You should be able to hear something but it will not be enough
to move a watt meter.
Check that the strip is getting +10V on the OSC 10V pin when the
transmitter is "Keyed" and +10 continuous on the REG 10V line.
If you have a wide range reciever you can tune to the expected
frequencys of each multiplier stage and hear if there is a problem.
If you dont have anything at the fundemental crystal frequency then I
would suspect the channel element or the crystal it's self. Did you
use a "EC" Icom in the transmit side? I have no experience in this
field but if I am correct in asumption a EC icom will not function in
the transmit side, only the RX side. A 5C needs to be used with a EC
in the RX side or 2 2C Icoms, one in each.
On 5/13/05, Chuck Kelsey <[EMAIL PROTECTED]> wrote:
> Has the exciter been aligned? You'll get no RF output if it is way out of
> alignment.
>
> Chuck
> WB2EDV
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
