Hi Les Use the Audio interface as one would use for your standard setup and if you could imagine place the Zetron input and output audio in a parallel fashion .In this way all dtmf etc would be used normally. With you ussing it to control the tail you would have the cos line connected.
I am sure that you are are aware that one can use this panel for carrier operated squelch only or a combination of carrier as well as tone access.I have the main ch1 uhf Naturn linked this way and on irlp 8300 for years operating a zetron 38A as a carrier only repeater. See repeater page http://members.harc.org.za/zs5wt Regards Bradley Glen ZS5WT South Africa East Coast --- Les <[EMAIL PROTECTED]> wrote: > The Zetron Model 38A Tone Panel I am using for our > local 2M repeater > ait is only used for ident & tail functions & I do > not want the > repeater audio routed through it. Therefore I need > to modify the panel > so audio still goes in for DTMF control purposes & > the panel can > generate confirmation tones for commands. Removing > jumper 3 from the > board prevents the repeater audio passing through > the panel but it > also stops audio input & therefore no DTMF control. > As i Don't have a > Circuit Could someone please look at this > > Thanks > > > > > > > > > > > Yahoo! Groups Links > > > [EMAIL PROTECTED] > > > > > __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
