I've got two of the polyphasors today. They will ship via USPS Priority Mail for about $4.00 If you want them, send me an address.
At 06:42 PM 12/4/2005 -0500, you wrote: >Sounds good, I would be willing to try it, as I plan on using "n" >connectors. Here is my e-mail address: [EMAIL PROTECTED] > >Thanks, > >Jim >----- Original Message ----- >From: "Joe" <[EMAIL PROTECTED]> >To: <[email protected]> >Sent: Sunday, December 04, 2005 5:30 PM >Subject: Re: [Repeater-Builder] Source for RF enclos > > > >I have used old Polyphasor surge suppressors for RF tight boxes, look at: > > > > http://www.polyphaser.com/kommerce_productdetail.aspx?item=IS-PT50HN > > > > These are 4.25" long, 2.25" wide and 1.25" deep outside dimensions. They > > are cast aluminum, so the inside dimensions will be less. I can't find > > the > > Hamtronics preamp I have, but I think it will fit inside. The case has 2 > > N > > female connectors, one on each end. I have a few of these around, you can > > have one for the postage. > > > > 73, Joe, K1ike > > > > At 09:50 AM 12/1/2005 -0500, you wrote: > >>I have a Hamtronics LNP VHF Preselector board. I would like to install > >>it > >>in a RF tight box. Checked with Hamtronics and they have no such item and > >>no advise as to where to find one. I want to install the board in a metal > >>box and have the antenna leads come out to two female N connectors, and a > >>12 > >>vdc through a feed-thru connector for power. Their is no room to install > >>it > >>within the receiver. > >> > >>Thanks, > >> > >>Jim, K8COP > > > > > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > > > > > > > > > >Yahoo! Groups Links > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
