Stephen Rice wrote:
>Well Kevin I sent some questions to the ICS group but pretty much got all
>the answers by playing with a touch tone pad and some wires so I could
>program using the Cntrl input. Messages aren't approved yet so don't show up
>on the group ! What I found is there are 2 errors on page 10 regarding Pin
>description on PL1. Pin4 is not audio for the Cntrl Rec(it is gnd according
>to schematic) and pin 7 which is labeled Cntrl rec cos input(schematic says
>it is the squelch wiper) . That was for my book that just arrived a week
>ago.
>
I'll take the blame for both of these changes. These changes were
implemented because I suggested to Brian that moving the Control
Receiver connections off of the Main plug would allow the repeater
builder to make all necessary connections from the Micor to the
controller on just one plug, (IE: moving the Squelch Wiper to the Main
port.
I'll also take to blame for not helping Brian with the manual as I said
I would 6 months or a year ago, but a lot has transpired since then and
I simply haven't had the time.
>As for the connector I also used a 10 conductor stranded hard drive ribbon
>cable. I figured it would look nice and neat when in the cage.
>
Yea, that cable can sometimes be easily broken. Individual stranded
wires of the right size may be difficult to find. I use from a roll of
25 conductor cable that was originally designed for printers, works great.
Kevin
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
