Some controllers also require a valid COR signal before they'll recognize the DTMF tones, so you might want to try manually activating that line and see if the controller is any happier.
The voter might just provide an audio output without any COR indication, or perhaps it's an option you need to configure. The other thing is insufficient, or too much, audio level, or an imbalance between the low tones and the high tones. Using flat instead of de-emphasized audio to feed the controller could cause that kind of imbalance. Bob M. ====== --- Mathew Quaife <[EMAIL PROTECTED]> wrote: > Hi Dwayne, I am able to hear the tones come out > through the repeater, and they sound fine, and I can > get it to work the echolink box just fine, and those > tones comes through all 5 receivers just fine. But > as for any commands for the controller, they just > will not let me do anything. I can see them on the > service monitor and they look good there as well. > > Mathew > > > ldgelectronics <[EMAIL PROTECTED]> wrote: > Put a scope on the audio output of the voter and > see if the tones are > getting through. > > If not, put the scope on the audio input of one of > the receivers that > you are testing and see if the tones are there. > > If not, go back to the remote receiver and put a > scope on the receiver > to see if the tones are there. > > If you have a controller on your remote receiver, > make sure it's set > to pass touch tones. Many controllers will mute > touch tones (by > default). > > Dwayne Kincaid > > > > > > Ok, all seems to be working, I have five channels > up and running, > they all seem to vote well. The only issue that I > have now is that I > cannot get the controller to accept any DTMF > commands from any of the > receivers. The echolink controller will accept the > commands just > fine, which goes through the controller. Any ideas? > > > > Mathew > > N9LV __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
