Well, here is the setup, and the problem:
Setup:
Moto Mitek trunk mobile on 70CM with CAT 250 controller, and control
head intact (mic disconnected). TX-RX duplexers (GE flavor, 3 cavity)
retuned. Uses stock tone board for incoming tone, Com-Spec board for
outgoing. Running about 25W into duplexer.
Problem:
Worked OK for a month in the shop on a small antenna, about a day at
the site, then now the RX audio is not there unless you are at the
site. Also you get a wierd growling like feedback and cycling of the
TX for a minute.
Suggestions:
??
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
