Standard spacing for UHF repeaters is 5 MHz.
Dick
----- Original Message -----
From: "larry" <[EMAIL PROTECTED]>
To: <Repeater-Builder@yahoogroups.com>
Sent: 27 January, 2006 08:46
Subject: Re: [Repeater-Builder] RFS 6MC450S DIPLEXER
HI...
It has been a while since I was on 450 mhz.. but I believe the spacing
between receiver and transmitter, on 450, is some where around 1.2 mhz....
not 600 khz....
Larry ve3fxq
----- Original Message -----
From: "Ian" <[EMAIL PROTECTED]>
To: <Repeater-Builder@yahoogroups.com>
Sent: Friday, January 27, 2006 8:23 AM
Subject: [Repeater-Builder] RFS 6MC450S DIPLEXER
> Hi guys .I have the above diplexer and have it tunned to 481.825 and
> 487.025 and it works but if the repeater is tx for a while the weak
> signal breaks down and crackles and after a while it comes back clear
> and then breaks down.On my service monitor the notches show a reading
> of -65db with 0 db signal on the tx and rx side.Any sugestions.Can it
> be a problem with insertion loss .Thanks
> Ian
>
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
Yahoo! Groups Links
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
