--- In Repeater-Builder@yahoogroups.com, "Dave VanHorn" <[EMAIL PROTECTED]> wrote: > > I just picked up a little problem, my PL boards are dropping out > sometimes when I have a valid PL. > > Can anyone tell me offhand what the PL signal voltage should be at the > input to the boards? (TS-32 in this case) I have about 0.8Vpp, which I > would have thought was enough. >
ComSpec's web site does not specify a level but the troubleshooting section in the instruction sheet for the TS-32 implies a 100 mV signal. Here is the link: http://www.com-spec.com/insheet/ts107.pdf Check the Decoder Input section on page 3 as well as the troubleshooting section on page 6. Scott Madison, WN1B Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/