If you trying to tie two Micor Stations together, follow the Motorola Base and Repeater Stations, Control and Applications Manual 68-81025E60 carefully.
We did that here and it works flawlessly. As I remember, takes 5 wires to complete it successfully. Hope this helps, Neil - WA6KLA Kevin King wrote: > > I I understand, you are trying to tie two stock Micor base/rt units > together? I think this configuration is discussed in the Micor base > manual. Let me see if I can find it. > > This is what was common with a lowband base it was tied to a control > link. Oh I can see the drawing in my head. the pages show the little > house (dispatch) and the car with the radios on the mountain. It > then talks about the different configurations available. With this > info you them can go make sure all the jumpers on the back plane and > control boards. > > I will try to find the stuff and help. Hopefully one of the others > on the list, (that sleep with the docs!) will pop in and help out. > > Kevin King SCSA BSCIS > ARS KC6OVD > GMRS KAG0378 > EIEIO 2722 > Acworth Georgia > > -----Original Message----- > From: [email protected] > [mailto:[EMAIL PROTECTED] Behalf Of let_cyber > Sent: Sunday, January 29, 2006 11:13 PM > To: [email protected] > Subject: [Repeater-Builder] Micor has me stumped > > I have both a vhf and uhf Micor repeater that I'm interfacing. > > I now know a whole lot more about Micor repeaters than I really wanted > to. The short version of the problem is as follows: > > The COS signal from the audio/squelch board goes away when the TX is > enabled. If you transmit a continuous carrier on the input, The COS > comes up for a split second, keys the TX then goes away. After the > hangtime expires and the TX drops, the whole things starts again. > > I have the exciter and RX into 50 ohm loads. If i put the A/S board > and squelch gate into the uhf unit, it works fine. I have checked and > double checked everything. It just doesnt make any sense. Any ideas > would be greatly appreciated. > > Al KB2AYU > > Yahoo! Groups Links > > > Yahoo! Groups Links > > > > Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
