Re: [Repeater-Builder] Digest Number 3664

[N5IUF]

More than likely the cause of your problem was the connection between the two boards developed a cold solder joint and began to ark.  This happens all the time with this PA.  It may not have had anything to do with your load.  If you have 70W going in and 4W reflected, that's about a 1.65:1 VSWR, which is not that bad.   Chris   In a message dated 3/13/2006 5:54:44 P.M. Central Standard Time, Repeater-Builder@yahoogroups.com writes: Here's the photos of a *VHF* PA that didn't get the board to board jumper mod and the results of driving it into a load that wasn't 50 Ohm that was probably reactive in some way also...   YAHOO! GROUPS LINKS  Visit your group "Repeater-Builder" on the web.    To unsubscribe from this group, send an email to:  [EMAIL PROTECTED]    Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.